Monday, 18 April 2016

Know the use of chambers to test gas warning providers

What is gas warning system?
The gas warning system is a lifesaving system that monitors the atmosphere within any enclosed space. As the gas that is being monitored gets increased above a preset threshold level, an acoustic alarm is triggered, so that the caretaker of this monitor can look into the matter.
The chambers used to test the devices of gas warning are built and operated differently. The basic work of gas warning devices is to alarm you is to give you an alarm if there is any gas leakage in the system. They can be used for domestic usages too. In that case, usage of gas is also reduced. The works that the device will be doing for you are all specifying the risks that are affiliated with. So, the testing part is even more critical. A vacuum high-pressure test chamber is usually designed for the purpose.

The style of operation
Before moving to any other thing, it is important to understand the parameters that the testing device will be checking. In the case of the devices providing a gas warning, there are three issues to be checked.
·         Temperature
·         Pressure, and
·         Humidity
The parameters are changed in all the tests. It is to be noted that only one parameter is to be changed in a single test, where other two will remain constant. This is to ensure that the device is reading the values for all the alterations separately. The test is to be carried out in a synthetic atmosphere. After it is tested in the synthetic air, the same test has to be pursued in an atmosphere of fuel gas. The quantity or the density of the gas in the cold heat climate vacuum must be as per the norms. Both the tests will be showing the signal that the gas device will show at the end.

The signals received, according to the change of parameters are recorded and expressed in the form of a graph. The output is usually stored in the form of data in carriers. The components that are used in the test are made of stainless steel. It has to be noticed that silicon never comes in contact with any of the test elements. It will totally destroy the specimen.

Controlling the test

The test is controlled through a PC. The software is installed to run the setup. It has to be mounted on a controller named as STRANGE. The door of the cold heat climate vacuum test chamber will be opening and closing in a pneumatic frequency. While the door will be opened, the external illuminations will turn on. For the support of the test, the chamber is fixed to the bottom. However, to move the chamber at the middle, there are castor wheels attached. 

No comments:

Post a Comment